[. . . ] The beverage size can be changed (see section “Changing volume dispensed”). General Fill the water tank with fresh, uncarbonated water only, and if possible, use only beans for fully automatic coffee and espresso machines. Do not use coffee beans that have been glazed, caramelized or treated with other additives containing sugar, since they will block the grinding unit. This appliance can be adjusted for use with different water hardness values (see “Set­ ting the water hardness”). [. . . ] Note: If no button is pressed within 90 ­ econds, the appliance switches to s stand-by mode without saving the new settings. The appliance must be rinsed when a filter is first used and after changing the filter. —● Fill the tank with water up to the “0, 5 l” mark. —● When water stops coming out of the nozzle 8, set the dial back to “O”. —● Fill the water tank and the water pipes (see “Switching on the appliance / Filling the system”). Adjusting the grinding unit Sliding switch 15 adjusts the degree of grinding, from coarse to fine. Warning ¡¡ Adjust the grinding unit only while it is running!—● While the grinding unit is running, move the sliding switch 15 to the desired posi­ tion: the smaller the dots, the finer the grind. Ii new setting will not become apparent The until the second or third cup is brewed. Tip: For dark roast coffee beans, choose a coarser grind; for light roast beans, select a finer grind. —● To do this, press and hold the dispensing button 3 E and the button 5 h at the same time for at least 5 seconds. —● Press the dispensing button 3 E or 4 F once again within 3 seconds of brewing. 16 en Steam for foaming milk The appliance must be ready for use. You can foam the milk first and add the coffee on top, or foam the milk separately and pour it into the coffee. —● Immerse the nozzle 8 deep into the milk, but do not let it touch the bottom of the cup. —● As soon as the LED J lights up, turn the rotary button 6 to g / h. Risk ¡¡ of scalding When the dial 6 is set to g / h, the nozzle 8 may sputter. Ii foam more milk, press the steam To button h again and repeat the whole process. Steam for heating drinks Risk ¡¡ of burns The nozzle gets very hot. —● As soon as the LED J lights up, turn the rotary button 6 to g / h. Risk ¡¡ of scalding When the dial 6 is set to g / h, the nozzle 8 may sputter a little. Ii generate more steam, press the steam To button h again and repeat the whole process. [. . . ] —● As soon as the LED J lights up, turn the rotary button 6 to g / h. —● When nozzle 8 stops releasing steam, turn dial back to “O”. Disposal A This appliance is labelled in accordance with the European Directive 2002/96/EG relating to waste electrical and electronic equipment – WEEE. The directive provides the framework for the EU-wide take-back and disposal of end-of-life appliances. [. . . ]